How to install the die between the material holes of the bending machine?

Adjustment of grinding tools: the die base of the CNC bending machine is the self-made rear die base, with uniform specification. The total width of the lower die plate is consistent with the total width of the "U" type operation platform. It has the effect of adjusting the grinding tool according to the regulations of aluminum profile. The pressing spring of the guide sleeve specification of the abrasive tool has a symmetrical length, which is used to spring back automatically after the stamping die (the key is to deal with the harm of the unconnected guide slide to the lower die and bending machine).

It is impossible for the hardware mold of CNC bending machine to be based on punching machine and punching machine. The root cause is the existence of front plate of equipment (in the middle of U-shaped operation platform), which is more difficult. Raw material sewage, usually choose side to back sewage, pay attention to stable sewage throughout the whole process of work.

The numerical control bending machine is close to but can not cover the lower die guide hole. In order to prevent the over travel damage of the grinding tool and the lower die, the grinding tool and the locating pin are bruised. The height width ratio of the upper die is the same. In other words, the blade is symmetrical and sharp. If it is not symmetrical, copper must be used. Paper is basically flat. Because the stamping die does not have the same plan, to avoid deformation of steel parts.

The height width ratio of the elbow opening shall be the same, and the "t" bending machine shall be pressed on the upper plate from beginning to end. In order to prevent the grinding tool from springing up suddenly by the spring of the locating pin, open the lower mold to get rid of the lower mold and the upper mold quickly. Put eight pieces into standard spare parts for maintenance and replacement.

The raw material holes have short spacing, so it is not allowed to install abrasives, to produce porous structure abrasives, or to open holes at spacing. Try to put the parts on the working table on the working table, that is, the guide slide fails when the equipment is working, that is, the center of gravity and the management center of the downward force of the guide slide of the CNC lathe. The same force is applied to the gallery holes.